Issues Installing the MM Solid Base Ring

I just got the sizing ring kit from mature metal. My current CB 6ks uses a split ring, which I’ve become quite good at handling. When testing out the two base rings that are closest to my usual CD size, I was surprised by how tough it was to secure a solid base ring. I applied lube to both the scrotum and the ring itself; then came ball after ball, followed by the shaft. It took me several attempts before I finally got it on successfully. Perhaps I’m using too much lubricant? Typically, getting the first ball through is straightforward, but the second one can be quite a struggle, while the shaft slides in easily. Often, as I push the first one through, the second one gets dragged along “inside” with it. Most of you are likely chuckling at my struggles, but after multiple tries, I ended up feeling pretty sore. For what it’s worth, I tend to be quite high and tight. Just like figuring out how to put on my current CD required trial and error, perhaps some of you MM wearers have tips that could help me overcome this solid ring installation challenge. Any advice??:?

I use a 1 7/8" ring on my cb6000s. After ordering sizing rings, I discovered that the 2" size was actually the smallest one I could manage. I haven't received my Jailbird yet, but I’ll share how it goes once it arrives.

Hint: Start by taking a long shower in hot water first.

I like to skip lube entirely when putting on the ring. The friction between my skin and the ring helps keep things in place. It’s also tougher when you’re dealing with a new device, for two reasons. First, you aren’t used to that specific ring yet; different shapes, diameters, and materials each require their own approach. Second, there's excitement involved. Ideally, you’d be relaxed without being aroused, but it’s hard not to get excited right after opening up your shiny new toy. A hot shower helps as well. -A

I’ve faced a similar issue when working with solid rings. After plenty of attempts, I found a method that works for me since one side is larger than the other. I always send the bigger ball through first. Then, I position it close to the ring and pull as much extra skin toward the "smaller" side as possible. Once that’s done, the second ball slides in easily. Finally, our chastity device goes through last. After pulling and tugging everything into a comfortable spot, I’m ready for the cage. Taking off the ring requires doing things in reverse; my larger one just won’t come out first.