Introductions discussion

As I keep searching for the best ready-made device, I’ve uncovered a few new details: Here are two updates on my findings: 1.) My cage isn’t actually 81mm long as I believed. The stainless steel options from Chinese sellers on eBay or Amazon typically come in set sizes: 45mm (small), 65mm (medium), 85mm (long), and 100mm (extra large). Nicoftime is spot on; you can’t just pick any size like ordering nuggets—you’re limited to specific counts. Looking back at my past purchases, I likely bought four of the same model with different looks without realizing it until last night. So, unless I drop $350 for a custom fit, I’ll always end up with a cage that’s either 3mm-7mm too big or 10mm-17mm too short. 2.) Yes, my underside penile length is 52mm when completely flaccid. I measured this more than ten times during the day using a metric ruler from base to tip. I believe that’s the correct starting point for measuring length. The potential error lies in how I calculated the total length including the testicles. Since I’ve forgotten my exact method, I’ll stick with the more reliable 52mm underside figure. My previous claim of being 82mm flaccid was an assumption since I wasn’t entirely sure. There’s a 99% probability that I’m actually 76mm…I still haven’t figured out how to measure the top side when unsure where exactly to begin. Anyway, I recently acquired a medium-sized, somewhat loose device measuring 65mm (with a 45mm cage). I bought it some time ago and used up leftover gift card balance. My flaccid length from sack to tip is definitely 52mm. A cage that sits about 7mm shorter than my flaccid size feels right, but one over 13mm shorter might cause significant pain when erect…or perhaps not.