Chastity device discussions and reviews discussion

Hi there. I’m planning to purchase my first custom-fitted cage from Evotion and, trying to cut down on reorders, have been reading up as much as possible on the suggested measurements. There are two minor questions that haven’t yet received answers.

(1) The site states: “Prince Albert Depth (optional) Please tell us the depth of your piercing, from the very tip of your penis to the center of the piercing hole or jewelry. Please measure carefully!” Should this be a horizontal measurement using a straight ruler to determine how far back horizontally the PA sits? Or should I use a flexible tape wrapped in cloth measuring from the end of the urethra up to the PA?

(2) The site states: “Shaft Circumference or Diameter * Give us the circumference of your flaccid shaft. A cloth measuring tape can be used to measure around the shaft while flaccid. Devices ordered too large will fall down and put pressure on the piercing. There is a lip around the inside of the device that will be a little bit smaller than your requested shaft size. Most people have a circumference between 80mm and 110mm, or a diameter between 25mm and 35mm.” I’m noticing quite a lot of variation in my shaft circumference depending on where I measure it. Specifically, the area directly under the glans is much smaller than other spots. That’s the size that ultimately decides if the cage fits/rests properly on the glans, but this might already be accounted for since the site mentions the cage “lip” will be slightly smaller than the rest. The center of the shaft circumference is noticeably larger than elsewhere. Any thoughts on whether to go with an average here? Or a max size so I avoid squeezing and developing edema? There have been many helpful tips about measuring in these forums, so thank you all for sharing your knowledge!:)